VAL Avionics NAV 2000 Instalační příručka stáhnout pdf (Strana 41)

100

101

System Planning

SkyView System Installation Guide - Revision R 2-19

Figure 9 - SkyView System with Two Redundant Displays, One EMS, Two Backup Batteries (One per Display),

Two Redundant GPS, Two Redundant ADAHRS, Two Servos, and one Transponder using a hub (recommended

installation method)

Note, that in Figure 9, each SV-GPS-250’s power, ground, and output wires are

connected to both displays on different serial ports. The primary SV-GPS-250

should be connected to serial port 5 on each display. The secondary SV-GPS-250

should be connected on another serial port on each display.

Additionally, if there are both multiple displays and multiple SV-GPS-250 units in

the system, power for the secondary GPS should be sourced from the GPS power

wire on the second display – in other words, each SV-GPS-250 should receive

power from a different display. Reference the SV-GPS-250 Installation and

Configuration Section for more information on this configuration.

HSI Requirements

SkyView’s HSI overlay on the PFD DG can be driven by its own built-in Navigation Mapping

software. Additionally, external GPS and NAV radio sources can be used as well. Reference the

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 400 401

Komentáře k této Příručce

Žádné komentáře

VAL Avionics NAV 2000 Instalační příručka Strana 41

Komentáře k této Příručce