VAL Avionics NAV 2000 Instalační příručka stáhnout pdf (Strana 39)

100

101

System Planning

SkyView System Installation Guide - Revision R 2-17

Figure 7–SkyView System with Two Redundant Displays, One EMS, Two Backup Batteries (One per Display), One

GPS, and Two Redundant ADAHRS

Note, that in Figure 7, the SV-GPS-250’s power, ground, and output wires are

connected to both displays.

The following diagrams show two different ways to lay out a more complex system in which

there are more SkyView Network modules than available SkyView Network ports.

The first diagram reflects the way that one would typically build a network when purchasing

components prior to March 2012 before the SV-NET-HUB was available. It uses splitters to

create all additional SkyView Network connections. This connection methodology is still valid

and supported, although the use of a SV-NET-HUB is preferred going forward.

The second diagram reflects the way one can build a network utilizing the SV-NET-HUB to

expand the number of available SkyView Network ports instead of splitters. It is both less

expensive and utilizes fewer total connections (and no gender changers) when compared with

the splitter-based method. Note that a splitter is still useful for wiring two co-located

redundant ADAHRS modules. In most installations, this is the only application of the SV-NET-SPL

that is necessary when utilizing the SV-NET-HUB to build a SkyView Network.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 400 401

Komentáře k této Příručce

Žádné komentáře

VAL Avionics NAV 2000 Instalační příručka Strana 39

Komentáře k této Příručce